I'm programming activities on an X1. I have a Sony Bravia TV, a Denon AVR-X6700H and numerous streaming boxes successfully setup as devices on the X1. When programming Activities, I can create one for Roku, for example:
- select Devices: Sony TV, Denon AVR, Roku Ultra
- select power state: Sony TV, Denon AVR (Roku is always on)
- control volume keys: Denon AVR
- Activity name: "Watch Roku"
- Source Switching Mode: Swith with one-click
- Source: Media Player (on Denon AVR): Roku is connected to the Denon AVR using the HDMI port labeled "Media Player"
- Source List: HDMI3 (on Sony TV)
This activity works fine after intial programming.
I then setup another activty for Apple TV:
- select Devices: Sony TV, Denon AVR, Apple TV
- select power state: Sony TV, Denon AVR (Apply TV is always on)
- control volume keys: Denon AVR
- Activity name: "Watch Apple TV"
- Source Switching Mode: Swith with one-click
- Source: Blu-Ray (on Denon AVR): Apple TV is connected to the Denon AVR using the HDMI port labeled "BLu-ray"
- Source List: HDMI3 (on Sony TV)
This activity works fine on initial programming.
If I use the original "Watch Roku" activity, it no longer works as it doesn't switch the Media Player HDMI source on the Denon AVR. If I go back to edit the "Watch Roku" activity, the Start-up Sequence now lists the Source as Blu-Ray, instead of Media Player. If I change it to Media Player, the activity works again, but then the "Watch Apple TV" activity is broken as its Start-up Sequence has been over-written from Blu-Ray to Media Player.
The Activity progamming seems broken in that it uses the Source from the most recently programmed Activity for all Activities.
